Induction Heating steel mandrel tip
Views Send Enquiry
Objective Heat a water-cooled steel mandrel to 700°F (371ºC) to form a high quality Teflon catheter tip.
Material Teflon catheter tubing, mandrel assembly
Temperature 600-700°F (315-371ºC)
Frequency 376 kHz
Equipment • Power of 10kW induction heating system, equipped with a remote workhead containing one 0.66μF capacitor.
• An induction heating coil designed and developed specifically for this application.
Process A two turn coil is used to heat the steel mandrel to 660ºF (371ºC) in 2.7 seconds. To form the catheter tip, RF power is applied while the catheter is held over the mandrel. The tubing is then pushed on to the mandrel to form a consistent, even tip.
Results/Benefits Induction heating provides:
• Precise, repeatable application of heat
• Non-contact heating
• Faster cycle times
Heating steel mandrel tip
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction heating bolt
induction heating steel rod by UM-40AB-HF
induction heating end of pipeline by 160kw induction heater
induction heating steel plates by auto feed system with 120KW induction heater
induction heating cambered work-piece by 160KW power supply
Induction heating for Plastic Reflow With Catheter Tubing
U shape induction coil for heating hole
induction heating steel rod with double coils
Newest Comment
No Comment
Post Comment