Induction Heating brass mandrel die
Views Send Enquiry
Objective Water-cooled brass mandrel die, nylon LDPE catheter, “K” type thermocouple and temperature controller.
Material materials, supplies involved in the application
Temperature 400°F (204°C)
Frequency 325kHz
Equipment Power of 10kW induction heating system, remote heat station containing one 0.66 microfarad capacitor.
Process A two turn plate concentrator coil is used to heat the die. To measure the temperature on the ID and establish the time-totemperature relationship, the thermocouple is inserted inside the brass die. RF power is applied for 3 seconds to heat the die to 400°F (204°C). The nylon tube is pushed into the die and formed into a catheter.
Results/Benefits Induction heating provides:
• Increased throughput and reduced cycle time
• Consistent and repeatable results
• Clean heating
• Precise temperature control
Heating brass mandrel die
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction brass soldering for copper bricks
induction brass soldering stator ends of wind driven generator within 2 seconds
ultra-high frequency induction brass soldering
induction brass solering_2
induction brass solering_1
induction brass soldering_2
induction brass soldering_1
induction brass soldering
Newest Comment
No Comment
Post Comment