Induction Soldering brass tubes
Views Send Enquiry
Objective: Soldering two brass tubes measuring 3/4″ and 1/4″ together for use as cellular phone antennas. The lengths of tubes range from four (4) feet to twelve (12) feet, and must be soldered along the axial side. The joint is to be made using 60/40 Tin Lead Solder and Kestor Rosin paste flux.
Material: Brass Tubes measuring 3/4″ and 1/4″ 60/40 Tin Lead Solder Kestor Rosin Flux
Temperature: 375°F
Application: Through the use of the the Power of 15KW,15kW output solid state induction power supply along with a unique five (5) turn 12″ long channel coil, the following results were achieved:
* 375°F was reached and the solder flowed after a heating period of 35 seconds.
* A production rate of 24″ per minute was determined to be adequate.
* A quality solder fillet was observed after heating and cooling
Equipment: Power of 15KW,15kW output solid state induction power supply including one (1) remote heat station containing two (2) capacitors, and a unique five (5) turn channel coil made from 3/16″ copper tubing and measuring 1 1/4″ by 12″.
Frequency: 75 kHz
Soldering brass tubes
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction brass soldering for copper bricks
induction brass soldering stator ends of wind driven generator within 2 seconds
ultra-high frequency induction brass soldering
induction brass solering_2
induction brass solering_1
induction brass soldering_2
induction brass soldering_1
induction brass soldering
Newest Comment
No Comment
Post Comment