Induction Soldering brass rings
Views Send Enquiry
Objective: To heat 1 3/4″, 3″ and 6″ diameter brass slip rings and a sheathed copper wire assembly to 3600 F for soldering within three (3) to six (6) seconds. Currently production is accomplished by using a soldering iron and stick feeding rosin cored solder. This process leaves unwanted solder on the side of the slip ring where the soldering iron makes contact. The customer would like to see an increase in joint quality without sacrificing time.
Material: 303 Brass Slip Rings of 1 3/4″, 3″ and 6″ diameters. Sheathed Copper Wire Assembly.
Resin Core Solder, 37% Pb, 63% Sn.
Temperature: 3750F
Application: Through laboratory testing, the Power of 10KW,10kW output solid state induction power supply along with a unique four (4) turn “ear muff” type coil produced the following results:
* Times to reach 3750 F are as listed below:
- 1 3/4″ in 3 seconds
- 3″ in 3-4 seconds
- 6″ in 5 seconds
* Adequate solder flow was observed producing a clean joint.
* Solder preforms are recommended to speed up production.
* Side loading was facilitated by the unique four (4) turn “ear muff” style coil.
Equipment: Power of 10KW,10KW output solid state induction power supply including one (1) remote heat station containing one (1) 1.0 μFcapacitor, a 4-20mA input for fast ramp simulation, and a unique four (4) turn “ear muff” style coil.
Frequency: 265 kHz
soldering brass rings
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction brass soldering for copper bricks
induction brass soldering stator ends of wind driven generator within 2 seconds
ultra-high frequency induction brass soldering
induction brass solering_2
induction brass solering_1
induction brass soldering_2
induction brass soldering_1
induction brass soldering
Newest Comment
No Comment
Post Comment