Induction Annealing Brass crimping
Views Send Enquiry
Objective To anneal a small area of an electrical contact for crimping
Material Brass female spade electrical contact with single transverse loop at end 0.5h(12.7mm) long, 0.25h(6.3mm) wide and 0.03h (0.8mm) thick, 1000oF (538oC)heat paint
Temperature 1000oF (538oC)
Frequency 300 kHz
Equipment . UM-30AB-UHF induction heating system, equipped with a remote workhead containing two 1.0uF capacitors for a total of 0.5 uF
. An induction heating coil designed and developed specifically for this application.
Process A one turn hairpin coil is used to heat the electrical contact to 1000oF (538oC) in 1.5 seconds. The contacts are in strips at 0.75h (19mm) centers and will run continuously at a rate of 50f (15.24m) per minute.
Results/Benefits Induction heating provides:
. Hands-free heating that involves no operator skill for manufacturing
. Pinpoint accuracy
. Consistent results
Material Brass female spade electrical contact with single transverse loop at end 0.5h(12.7mm) long, 0.25h(6.3mm) wide and 0.03h (0.8mm) thick, 1000oF (538oC)heat paint
Temperature 1000oF (538oC)
Frequency 300 kHz
Equipment . UM-30AB-UHF induction heating system, equipped with a remote workhead containing two 1.0uF capacitors for a total of 0.5 uF
. An induction heating coil designed and developed specifically for this application.
Process A one turn hairpin coil is used to heat the electrical contact to 1000oF (538oC) in 1.5 seconds. The contacts are in strips at 0.75h (19mm) centers and will run continuously at a rate of 50f (15.24m) per minute.
Results/Benefits Induction heating provides:
. Hands-free heating that involves no operator skill for manufacturing
. Pinpoint accuracy
. Consistent results
Electrical contact with 1000°F (538°C) temperature paint
Induction Heating is so precise that only the very end is heated to the desired temperature and melts the 1000°F (538°C) temperature paint
Next: Induction Annealing copper tubingPrevious: Induction Annealing steel shaft
Good
Bad
Related Content
induction brass soldering copper plate_2
induction annealing for stainless pipe
induction brass soldering for copper bricks
induction brass soldering stator ends of wind driven generator within 2 seconds
ultra-high frequency induction brass soldering
induction brass solering_2
induction brass solering_1
induction brass soldering_2
Hot
induction annealing for stainless pipe
induction annealing umbrella ribs by 60KW induction heater (UM-60AB-UHF)
induction annealing steel wire online
induction annealing steel umbrella ribs by 40KW induction heater (UM-40AB-HF)
induction annealing by horizontal type induction heater
induction annealing rod steel (steel bar)
induction annealing water channel
UHF induction annealing
Newest Comment
Post Comment