Induction Soldering wires onto connector
Views Send Enquiry
Objective Heat connector assemblies for soldering
Material Device assembly
Tin plated brass terminals Solder paste
Temperature 500°F (260°C) 5-7 seconds
Frequency 360 kHz
Equipment Power of 6 kW induction heating system equipped with a remote heat station, containing two 0.66 μF capacitor.
An induction heating coil designed and developed specifically for this application.
Process A single turn helical coil is used to heat the solder paste. The
connectors are placed inside the induction heating coil and RF power is applied for 5-7 seconds until the connector heats.
Solder paste is applied to the joint in two ways, stick-fed or manually.
Results/Benefits • Compared to using a manual soldering iron, induction
heating precisely applies heat to for higher quality solder joints
• This is ideal for integrating with an automated system. By stick- feeding the solder more aesthetically pleasing parts are produced.
Soldering wires onto connector
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Newest Comment
No Comment
Post Comment