Induction Soldering Steel to Brass
Views Send Enquiry
Objective
Heat an assembly of small, gold-plated steel connectors to a brass block.
Approx. 1/8” (3.2mm) diameter gold-plated steel connectors,
1”(25.4mm) square x 1/4” thick brass block ,600°F(315.6ºC),240 kHz
Temperature,Frequency,Equipment
6 kW induction heating system equipped with aremote workhead.
An induction heating coil designed and developed specifically for this application.
Process
A two-turn helical coil is used to provide uniform heat to parts
assembly. Solder paste and flux are applied to the joint area and power is applied for 20 seconds to solder the parts. Proper fixturing is needed to hold the parts in position.
Good
Bad
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
UHF handheld induction heater for brazing copper
UHF handheld induction heater for brazing brass
handheld induction coil for soldering brass
handheld induction coil for brazing brass
induction brass soldering for refrigerator pipes
induction brass soldering with D80mm red copper with 60% silver solder paste
induction brass soldering pipes for chiller
induction brass soldering for multi pipes
Newest Comment
No Comment
Post Comment