Induction Soldering Ferrule to Fiber Optic Cable
Views Send Enquiry
Objective To heat a gold-plated ferrule and fiber optic cable to 475°F within 8 seconds for a soldering application
Material Gold-plated ferrule tube, fiber optic cable, solder preform
Temperature 475 ºF
Frequency 270 kHz
Equipment Power of 6kW power supply with a specially designed induction coil.
Process A specially designed, two-turn plate concentrator coil was used to provide uniform heat to the fiber optic assembly. The assembly was placed in a specially designed fixture, then placed inside the induction coil. RF power was applied until the solder flowed and created a solid joint.
Results Consistent and repeatable results were achieved using the Power of 6 kW power supply and induction coil with a 5 to 7 second heat cycle, depending on the type of solder used (see solder chart below). Solder Heat Cycle
Soldering Ferrule to Fiber Optic Cable
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Newest Comment
No Comment
Post Comment