Induction Shrink fitting impeller blades to shaft
Views Send Enquiry
Objective Heat aluminum impeller blades to 200 ºF (93 ºC) and shrink fit onto a shaft.
Material Aluminum impeller blades with a .28” (7.109mm) bore, aluminum shaft
Temperature 200 ºF (93 ºC)
Frequency 255 kHz
Equipment • Power of 6 kW induction heating system, equipped with a remote workhead containing one 1.0μF capacitor.
• An induction heating coil designed and developed specifically for this application.
Process A split two turn helical coil is used to evenly heat the opening on the impeller blade. The impeller blade is heated for 20 seconds to reach the 200 ºF (93 ºC). The impeller blades are then removed from the coil & slipped over the shaft to
complete the shrink fitting application.
Results/Benefits Induction heating provides:
• Repeatable results
• Reduced cycle time, lower consumables cost
• Even distribution of heating
Shrink fitting impeller blades to shaft
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction heating inner surface
induction shrink fitting aluminium motor frame
induction shrink fitting coupling hub for oil pipes project by water cooled flexible induction coil
induction shrink fitting aluminum motors stators rotors
induction shrink fitting aluminum motors stators rotors
induction shrink fitting aluminum motors
induction shrink fitting aluminum motor frames to 350 celsius degree in 50 seconds by 60KW machine
induction shrink fitting
Newest Comment
No Comment
Post Comment