Induction Heating steel mandrel tip
Views Send Enquiry
Objective Heat a water-cooled steel mandrel to 700°F (371ºC) to form a high quality Teflon catheter tip.
Material Teflon catheter tubing, mandrel assembly
Temperature 600-700°F (315-371ºC)
Frequency 376 kHz
Equipment • Power of 10kW induction heating system, equipped with a remote workhead containing one 0.66μF capacitor.
• An induction heating coil designed and developed specifically for this application.
Process A two turn coil is used to heat the steel mandrel to 660ºF (371ºC) in 2.7 seconds. To form the catheter tip, RF power is applied while the catheter is held over the mandrel. The tubing is then pushed on to the mandrel to form a consistent, even tip.
Results/Benefits Induction heating provides:
• Precise, repeatable application of heat
• Non-contact heating
• Faster cycle times
Heating steel mandrel tip
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
Induction Heating multi wire bundles of rotor with different shape induction coils
induction heating bolt
induction heating steel rod by UM-40AB-HF
induction heating end of pipeline by 160kw induction heater
induction heating steel plates by auto feed system with 120KW induction heater
induction heating cambered work-piece by 160KW power supply
Induction heating for Plastic Reflow With Catheter Tubing
U shape induction coil for heating hole
Newest Comment
No Comment
Post Comment