Induction Heating Aluminum Auto Trim
Views Send Enquiry
Objective :To heat various sizes of aluminum auto trim to 500°F (260°C) at a rate of 30 ft. (9.1m) per minute for curing an adhesive.
Material: Magnetic steel and aluminum auto trim parts, coated with adhesive; 1.85” (47mm) ID ceramic tube
Temperature :500 °F (260°C)
Frequency :152 kHz
Equipment
• HF 25kW induction heating system equipped with a remote workhead with six 0.75μF capacitors for a total capacitance of 0.5 μF
• An induction heating coil designed and developed
specifically for this application.
Process :To simulate continuous production, a slide table/stepping motor arrangement and ceramic tube are used to move the parts through the eight turn helical coil at 30 ft. (9.1m) per minute. In continuous production, an infrared sensor can be used to measure the temperature of the aluminum after exiting the coil and adjust output of the power supply to maintain the required 500 °F (260°C).
Results/Benefits:
• Consistent, controllable heat
• Hands free operation
• Reliable, repeatable results
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction painting after induction bending for pipelines
induction heating steel plate
induction remove copper from aluminium
induction heating stator frame
induction heating graphite mould
difference between induction heating inner surface and outside surface of steel ring
induction heating steel pot bottom
induction heating for heat preservation
Newest Comment
No Comment
Post Comment