Induction Hardening bed knife blade
Views Send Enquiry
Objective Harden a selected area on an 18″(457.2mm) bed knife blade for a reel type lawn mower. The hardness desired is between 45 to 55 Rockwell C, and should be measured 0.062″(1.6mm) from the cutting edge.
Material 1070 Steel Bed Knife Blade measuring 18″(457.2mm) long, 1 17/32”wide (38.9mm) and 0.135″(3.4mm) thick.
Temperature 1550ºF(843.3ºC)
Frequency 108 kHz
Equipment • Power of 45kW induction heating system equipped with a remote workhead containing four (4) capacitors
totaling 1.0 μF
• An induction heating coil designed and developed
specifically for this application.
Process A single turn channel coil with ceramic guides is used to scan along the length of the blade for 30 seconds to reach 1550ºF (843.3ºC). Immediate quenching and rigid fixturing is necessary to prevent blade distortion.
Results/Benefits Induction heating provides:
• Precise & accurate placement of heat
• Consistent and repeatable results
• Non-contact clean heat
Material 1070 Steel Bed Knife Blade measuring 18″(457.2mm) long, 1 17/32”wide (38.9mm) and 0.135″(3.4mm) thick.
Temperature 1550ºF(843.3ºC)
Frequency 108 kHz
Equipment • Power of 45kW induction heating system equipped with a remote workhead containing four (4) capacitors
totaling 1.0 μF
• An induction heating coil designed and developed
specifically for this application.
Process A single turn channel coil with ceramic guides is used to scan along the length of the blade for 30 seconds to reach 1550ºF (843.3ºC). Immediate quenching and rigid fixturing is necessary to prevent blade distortion.
Results/Benefits Induction heating provides:
• Precise & accurate placement of heat
• Consistent and repeatable results
• Non-contact clean heat
Good
Bad
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction hardening surface of steel plate
induction hardening gear surface
induction hardening wheel gears
induction hardening TCT knife (tungsten carbide tool)
induction hardening knife edge (sickle blade)
induction hardening inner surface of steel pipe
induction hardening inner surface of steel ring by UHF induction heater
induction hardening inner surface of gear
Newest Comment
No Comment
Post Comment