Induction Shrink Fit Camshaft Gear
Views Send Enquiry
Objective: Heating a camshaft gear with a bore size of 1.630″ to shrink fit over a steel shaft that has a diameter of 1.632″. A temperature of 5000F is required for the gear to expand 0.002″ in order to slip over the shaft. Production is presently done at a rate of 15-20 gears per 24 hour shift by heating the gear on a hot plate. The hot plate heating cycle lasts for approximately 45 minutes.
The customer would like to explore the options available in terms of heating times and machine size.
Material: Steel Camshaft Gear measuring 7″ in diameter, 1″ thick, with a bore size of 1.630″.
Temperature: 5000F
Application: A unique three (3) turn helical coil along with the various UIHM solid state induction power supplies were used to achieve the following
results:
*5000F was reached in three (3) minutes while using the Power of 25KW,25 kW output solid state induction power supply.
* 5000F was reached in five (5), eight (8), and ten (10) minutes using the Power of 25KW,25 kW output solid state induction power supply.
*Even heating was observed as a result of the unique three (3) turn helical induction coil.
Equipment: Power of 25KW,25 kW output solid state induction power supplies respectively, including remote heat stations and a unique three turn helical coil made from 3/16″ copper tubing and having a 4.4″ inside diameter.
Frequency: 50 kHz
shrink fit Camshaft Gear
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction shrink fitting motor (stator or rotor)
induction installation (shrink fitting) couplings for Shaft Collar with flexible induction coil
induction shrink fitting wheel
induction shrink fitting stator
induction shrink fitting spindle
induction shrink fitting for rotor and stator
air cooled induction heating for fixing Nuclear Power Unit (loosen screw nut)
induction shrink fitting
Newest Comment
No Comment
Post Comment