Induction Solder Flex Circuits
Views Send Enquiry
Objective To heat multiple joints on flex circuit strips to 180-200°F within seven seconds for a soldering application.
Material Copper bonded to polyester flex circuit strips, Solder Plus Paste 63NC-A, 0.0625” thick Teflon sheets
Temperature 183°F
Frequency 278 kHz
Equipment Power of 6 kW power supply, remote heat station with one 1.2 μF capacitor and a specially designed induction coil.
Process A specially designed induction coil was used to provide even heat in the area where the fingers of the flex circuits overlap. Initial tests were done to establish a heating pattern and determine time-to-temperature. After a very light coat of the solder paste was applied to the circuit connections, a small amount of pressure was applied to the Teflon sheets to hold the circuits together. RF power was then applied for 6.5 seconds to flow the solder paste and bond the flex circuits
Results Consistent and repeatable results were achieved using the 6kW power supply in 6.5 seconds at 183°F.
Solder Flex Circuits
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Newest Comment
No Comment
Post Comment